该机主要用于框架结构的木质品的拼合组装。其组合尺寸大小可调,具有结构合理操作简单方便, 实用等特点。

安装及调试北京翻译

将该机放置于坚实的水泥地坪面上, 四脚垫平垫实, 拧紧因运输、吊装等原因而松动的螺栓。连接380V、50Hz电源, 确认油泵电机转向正确。

操作

根据木制品框架的尺寸调节上下横梁及压料座的位置, 按照操作面板上的按钮标识进行操作。遇到紧急情况按急停按钮。

注意事项

保持液压油洁净, 新机运行100小时后更换液压油。此后, 每运行2000小时更换液压油。本机选用HF-2 46#抗磨液压油北京翻译公司。

This equipment is mainly designed for the matching and assembling of wood products with frame structure. . With an adjustable assembling size dimension, it has the features of rational structure, simple and convenient operation and utility etc..

Installation and debugging.

Place this equipment on solid cement floor, level up the four legs, and tight the bolts that has become loose because of transportation and lifting etc. . Connect the equipment to 380V 50Hz power supply to confirm if the oil pump motor commutation is correct..

Operation.

Adjust the positions of upper and lower beams and swaging block in accordance with the frame dimension of wood products; the operation shall be in accordance with buttons identified on operation panel. . Press the emergency stop button if emergency occurs..

Matters need attention.

Keep the hydraulic oil clean, and change it after the new equipment has operated for 100 hours. . Hereafter, the hydraulic oil shall be changed for every 2,000 hours of operation. . This equipment uses HF-2 46# anti-wear hydraulic oil..